Driveway lifting in Sioux Falls was the right solution for a homeowner with several concrete concerns around the front of the home: settled driveway and walkway slabs, open joints, and a crack near the garage. Because the concrete was still a candidate for repair, the goal was to lift and stabilize the affected sections without tearing out the entire driveway.

Blackburn Foundation Repair completed the project over two days in November 2026. The crew used PolyLevel® to support and lift the settled slabs, removed the failed caulk, and sealed the joints and crack with gray NexusPro®.

Project at a Glance

  • Location: Sioux Falls, South Dakota
  • Concrete repaired: Driveway and front walkway
  • Installation time: Two days
  • Lifting material installed: 300 pounds of PolyLevel
  • Old caulk removed: 369 linear feet
  • Joints sealed: 369 linear feet with gray NexusPro
  • Crack repaired: 10 linear feet with gray NexusPro

The Problem: Settlement, Open Joints, and a Driveway Crack

Concrete is poured in separate slabs so it has room to move as temperatures change. When the soil below loses support, however, one slab can settle lower than the next. Open joints and cracks also allow water to reach the base below the concrete, where erosion and repeated freeze-thaw cycles can contribute to further movement.

In this project, the driveway and walkway needed more than new caulk. The affected slabs first needed to be lifted and supported so the surfaces could meet more evenly. After the lift, sealing the joints would help reduce water entry beneath the repaired concrete.

Open crack and joint in a Sioux Falls concrete driveway before repair
Before repair, an open crack and joint near the garage provided a path for water to reach the soil below the slab.

Step 1: Lift and Stabilize the Settled Slabs

The crew drilled small injection points in the affected concrete and installed PolyLevel beneath the slabs. The lightweight polyurethane expands below the concrete, fills voids, and allows trained installers to control the lift a little at a time.

The project record shows that 300 pounds of PolyLevel were installed across the driveway and walkway. The goal was not to make old concrete look newly poured; it was to restore support and improve the transitions between slabs while keeping the existing concrete in place.

Blackburn crew lifting a settled Sioux Falls driveway with PolyLevel equipment
During installation, the crew used specialized equipment to control the lift and restore support beneath the settled concrete.

Step 2: Remove Failed Caulk and Seal the Joints

Once the lifting work was complete, the crew removed 369 linear feet of failed caulk. That preparation matters because new sealant performs best when it can bond to a clean, properly prepared joint.

The team then installed 369 linear feet of gray NexusPro joint sealant and repaired another 10 linear feet of cracking. NexusPro is designed to remain flexible through seasonal concrete movement and to help keep water and debris out of the joints.

Sioux Falls driveway after PolyLevel lifting and NexusPro joint sealing
The completed driveway after lifting, stabilization, and gray NexusPro joint sealing.

The Result: A More Even, Better-Protected Concrete Surface

By the end of the second day, the driveway and walkway slabs had been lifted and stabilized, the worn caulk was gone, and the joints and crack had a clean, consistent seal. The repair preserved the existing concrete and addressed both the settlement and the openings that allowed water to reach the soil below.

The finished photos show the scope of the work across the driveway as well as the curved front walkway. Every property is different, but this Sioux Falls project is a good example of how lifting and joint sealing can work together when the slabs are still suitable for repair.

Curved Sioux Falls walkway after concrete leveling and joint sealing
The completed walkway has stabilized slabs and sealed joints that help limit water entry beneath the concrete.

Is Your Sioux Falls Driveway a Candidate for Lifting?

Concrete leveling may be appropriate when the slabs are mostly intact but have settled, tilted, or developed uneven transitions. Concrete that is badly crumbling or broken into many small pieces may need replacement instead. An on-site inspection is the best way to determine which repair fits the condition of the slab and the soil below it.

Read our Sioux Falls concrete-leveling comparison guide to see how PolyLevel compares with mudjacking and replacement. You can also learn more about Blackburn’s complete concrete leveling and repair services.

If your driveway, sidewalk, patio, or steps have settled, request a free concrete inspection or call 1-800-392-3389.

For a broader look at the area and services we offer, visit our Sioux Falls service area page.